Skip to main content

Wire electrical discharge machining (WEDM: Novicut-Series

Wire electrical discharge machining (WEDM) is an indispensable machining technique for producing complicated cutouts through difficult to machine metals without using high cost grinding or expensive formed tools.
 

Novicut-M

 

High speed Machine with a Reciprocating Brass / Molybdenum wire. This wire cut machine is with the lowest running cost in the market and can reach the highest removal rate of more than 220 mm2/min and a best roughness of Ra <= 0,8 The wire is continuously re-usable.

 

Novicut-P/U

 

Precision and high wire cut machine with continue fed copper/Brass-based wire for higher precision and high surface quality. The wire is usually made of brass or stratified copper, and is between 0.02 and 0.3 mm diameter and for single use

NOVICUT : Wirecutting re-invented

Wire cutting at a 70% lower cost!!

70% cheaper wire cutting!!

 

Who is not interedsted in this?

Wirecutting reinvented : Molybdenum Technology

Saving 70% on wire cutting cost

More details on Noviform-M-II

Molybden Technology :
Lowest cutting cost in the market

Combined with Zirconium guiding wheels guarantees the fastest precision cutting in the market

NEW 2018 July 
Wide angle Cutting with Molybdenium wire

Taper cutting : ±15°/80mm

Zirconium Guiding Wheels

increased stroke on U&V Axis : 70mm

 

Details Novicut-M-III Wide Angle
 

Precision without compromises

More details on Novicut-P

NOVICK® Wire EDM's are the right choice for you if you are looking for a machine that is more accurate, precise and less costly to operate.